Samsung MIM-H03UN User & Installation Manual page 12

Multi wi-fi kit, smart ac application
Hide thumbs Also See for MIM-H03UN:
Table of Contents

Advertisement

How to install Wi-Fi kit
• When installing a Wi-Fi kit with 10 m (32 . 8 feet) or more wire, the communication wire and power wire of a Wi-Fi kit
should be installed separately . (The Wi-Fi kit will malfunction because of electrical fault . )
CAUTION
• When installing a Wi-Fi kit on the wall, select proper thickness of wires in the consideration of the hole size for wire
on the wall .
• Wire for Wi-Fi kit communication and power
- When installing a Wi-Fi kit in a buried way, install the kit in accordance with U-terminal wiring Specification .
- When installing a Wi-Fi kit with 4 core PVC cable, peel off 30 cm (0 . 9 8 feet) of the sheath before installing .
(Recommendation: AWG22)
• Specification of compressed U-terminal for connecting Wi-Fi kit PCB
The maximum wiring length for communication and power : 50 m (164 feet)
• Tighten the fixing screws to the PCB terminal with less than 6N·cm torque . When the screws are tightened with
more than 6N·cm torque, the screw thread will be damaged .
6 . Run the Wi-Fi kit .
f When the Wi-Fi kit is turned on, all the lamps are turned on until system operates .
f
f After the system operates, tracking is performed automatically .
f
7 . Perform the tracking .
❋ ❋ Tracking : You can search the devices connected to the Wi-Fi kit with the tracking function . The devices connected to Wi-Fi
kit recognize that they are connected to the Wi-Fi kit . To monitor or control the system air conditioner with Wi-Fi
kit, tracking should be performed .
f When the Wi-Fi kit is turned on, the tracking is performed automatically . During the tracking, the lamp of
f
the Wi-Fi kit (
) (
f If the tracking is completed but the lamp (
f
case, check whether the connection of communication cable between indoor unit and outdoor unit is correct or is
affected by noise .
f If the configuration of indoor unit or outdoor unit is changed, tracking should be performed again manually by pressing
f
the button (SW3) inside the Wi-Fi kit . (Ⓑ-
• If you want to control the indoor unit with the Wi-Fi kit, indoor unit's centralized control usage option must be set to
"Enable" .
CAUTION
• If you want to control the indoor unit with the Wi-Fi kit, tracking must be done properly and connect the Wi-Fi kit to
a wired/wireless router .
NOTE
• When the tracking is completed correctly, the lamp (
wireless router to Wi-Fi kit is completed .
12
MULTI WIFI APP-NA_05417A-05_EN.indd 12
Wire range for
E
connection
W
Stud
D
AWG
F
G
L
22~16
t
) blinks .
) blinks, it means the Wi-Fi kit does not find connected indoor units . In this
)
Rated
Stud
size
size
mm
mm
mm
t
ΦD
2
2
0 . 2 5~
1 . 5
3
0 . 7
3 . 8 10 . 0 4 . 5
1 . 6 5
) is turned on until the process which connects the wired/
Basic size(mm)
G
E
F
W
L
6 . 5
6 . 0 21 . 2
2018-02-28 오전 11:08:35

Advertisement

Table of Contents
loading

Table of Contents