Important Notice; Safety Information - Sony FW-85BZ35F Reference Manual

NOTICE FOR CUSTOMERS IN THE UNITED
KINGDOM
A moulded plug complying with BS1363 is fitted to this equipment
for your safety and convenience.
Should the fuse in the plug supplied need to be replaced with the
same rating of fuse approved by ASTA or BSI to BS 1362 (i.e.,
marked with or ) must be used.
If the plug supplied with this equipment has a detachable fuse
cover, be sure to attach the fuse cover after you change the fuse.
Never use the plug without the fuse cover. If you should lose the
fuse cover, please contact your nearest Sony service station.
How to replace the fuse
Open the fuse compartment with a blade screwdriver, and
replace the fuse.
Please refer to the illustration that actually equipped with the
product.

IMPORTANT NOTICE

This product has been manufactured by or on behalf of Sony
Visual Products Inc.
EU Importer: Sony Europe Limited.
Inquiries to the EU Importer or related to product compliance
in Europe should be sent to the manufacturer's authorized
representative, Sony Belgium, bijkantoor van Sony Europe
Limited, Da Vincilaan 7-D1, 1935 Zaventem, Belgium.
Notice for Radio Equipment
Hereby, Sony Visual Products Inc. declares that
the radio equipment types FW-85BZ35F,
FW-75BZ35F, FW-65BZ35F, FW-55BZ35F,
FW-49BZ35F, FW-43BZ35F are in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address:
http://www.compliance.sony.de/
This radio equipment can be operated in the EU without
infringing applicable requirements on the use of radio spectrum.
FUSE

Safety Information

WARNING
Caution
Risk of explosion if the battery is replaced by an incorrect type.
Batteries must not be exposed to excessive heat such as
sunshine, fire or the like or extremely low air pressure that can
result in an explosion or leakage of flammable liquid or gas.
Stability Hazard
The LCD Monitor may fall, causing serious personal injury or
death.
Never place a LCD Monitor in an unstable location. A LCD Monitor
may fall, causing serious personal injury or death. Many injuries,
particularly to children, can be avoided by taking simple
precautions such as:
• Using cabinets or stands recommended by the manufacturer of
the LCD Monitor.
• Only using furniture that can safely support the LCD Monitor.
• Ensuring the LCD Monitor is not overhanging the edge of the
supporting furniture.
• Not placing the LCD Monitor on tall furniture (for example,
cupboards or bookcases) without anchoring both the furniture
and the LCD Monitor to a suitable support.
• Not placing the LCD Monitor on cloth or other materials that
may be located between the LCD Monitor and supporting
furniture.
• Educating children about the dangers of climbing on furniture
to reach the LCD Monitor or its controls.
If your existing LCD Monitor is being retained and relocated, the
same considerations as above should be applied.
Installation/Set-up
Install and use the LCD Monitor in accordance with the
instructions below in order to avoid any risk of fire, electric shock
or damage and/or injuries.
Installation
• The LCD Monitor should be installed near an easily accessible
mains socket.
• Place the LCD Monitor on a stable, level surface to prevent it
from falling over and causing personal injury or property
damage.
• Install the LCD Monitor where it cannot be pulled, pushed, or
knocked over.
• Install the LCD Monitor so that the LCD Monitor's Table-Top
Stand does not protrude out from the LCD Monitor stand (not
supplied). If the Table-Top Stand protrudes out from the LCD
Monitor stand, it may cause LCD Monitor set to topple over, fall
down, and cause personal injury or damage to the LCD Monitor.
GB
3
GB