Table of Contents
Advertisement
Factory data reset
You can reset your device to its original system state
and delete all data. After a factory data reset, the device
is restored to its default settings—the way it was when
you first purchased it and turned it on. Any apps you
installed, data you added and settings you customized
on your device will be lost. Also the firmware will be set
to its factory state and needs to be updated again.
Caution
• Performing a factory data reset will delete all data on
your device. Before you perform a factory data reset,
back up any important data saved on your device.
To perform a factory data reset:
1
Tap Settings
on the Home screen or on the All
Apps screen.
2
Swipe down and tap Backup & reset.
3
Tap Factory data reset.
X The Factory data reset window opens.
4
Tap Reset SpeechAir.
X The Reset window opens.
5
Tap Erase everything.
X SpeechAir turns off and restarts automatically.
Updating your device
Your device is controlled by an internal program called
firmware. As a part of ongoing product maintenance, the
firmware is upgraded and errors are corrected.
It is possible that a newer version (an 'update') of the
firmware has been released since you purchased the
device. In this case, you can easily update your device to
the latest version.
Update the firmware with Philips SpeechAir
management software. You can find the software on
the product website at
www.speechair.com/support
or implemented in Philips SpeechExec software. For
more information, see
Philips SpeechAir management
software.
Caution
• Before you update the firmware, make sure that your
device has at least 30% battery power left. This helps
to prevent the power supply being interrupted during
the update.
• Before you use other device functions, wait until the
firmware update is complete. Failures in the firmware
update might result in the device's malfunctioning.
Note
• To find out about new firmware versions, regularly
check our website at
www.philips.com/dictation.
• Before you can use Philips SpeechAir management
software, first install the software. For more
information, see
Install SpeechAir management
software.
Update the firmware with SpeechAir management
software
1
Download the firmware update file update.safw
from the website
www.speechair.com/support
computer.
2
Start Philips SpeechAir management software.
3
Make sure that SpeechAir is turned on and connect
the device to your computer.
4
On the device configuration window of the software,
go to SpeechAir > Firmware, and select the firmware
file on your computer.
5
Click Send to SpeechAir on the toolbar.
X A pop-up window confirming the successful
configuration transfer appears.
6
To apply the configuration to SpeechAir, disconnect
the device from the computer.
X The Update pop-up window appears on your
SpeechAir.
7
Tap Update now. If you want to update the firmware
at a later time, tap Postpone for 2 hours. You can
postpone the update three times. Afterwards,
the device will inform you that the firmware will
automatically be updated.
X SpeechAir turns off and starts the installation of
the update file.
X You can see the progress of the installation on the
screen.
X When the firmware update has finished,
SpeechAir restarts automatically.
Device and data management
to your
45
Advertisement
Table of Contents
