Table of Contents
Advertisement
2 SYSTEM CONFIGURATION
2.2 Applicable Systems
2 - 3
This section describes the applicable systems.
(1) Applicable modules and base units, and No. of modules
(a)
When mounted with a CPU module
For the CPU modules and base units applicable to the QJ71DN91 and
quantities for each CPU modules, refer to the user's manual for the CPU
module used.
• The user's manual (Hardware Design, Maintenance and Inspection) for
the CPU module used.
Remark
When the module is used with a C Controller module, refer to the user's manual for
the C Controller module.
(b)
Mounting to a MELSECNET/H remote I/O station
The QJ71DN91 cannot be mounted to any MELSECNET/H remote I/O
station.
Mount it to a CPU module on a master node.
(2) Supported software packages
To use the QJ71DN91, GX Works2 Version 1.575Z or later is required.
(3) Remote operation is not allowed from another DeviceNet node
Each DeviceNet node on DeviceNet cannot read/write/monitor the sequence
program or data of the programmable controller CPU where the QJ71DN91 is
installed.
MELSEC-Q
2 - 3
Advertisement
Table of Contents
Troubleshooting
