Sansui HDLCD2600 Owner's Manual page 16

Connections to other equipment
To connect the LCD TV to a PC (Personal Computer)
Before you connect this LCD TV to your PC, change the adjustment of your PC's Resolution and Refresh rate
(60 Hz).
Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the
VGA connector PC MONITOR on the back of the LCD TV. Attach the connectors firmly with the screws on the
plug. In case of a Multimedia computer, connect the audio cord to the audio output of your Multimedia
computer and to the AUDIO connector of the PC/HDMI AUDIO IN jack of the LCD TV.
Press INPUT SELECT on the remote control to select PC mode.
Switch on the computer. The LCD TV can operate as the computer monitor.
Left side of the LCD TV
To PC IN
PC/HDMI
NOTE:
•
The on-screen displays will have a different appearance in PC mode than in TV mode.
•
If there is no video signal from the PC when the unit is in PC mode, "NO SIGNAL" will appear on the TV-
screen.
16
VGA cable (not supplied)
Audio cord (not supplied)
AUDIO
IN jack
Monitor Display modes
MODE Resolution
VGA 640x480
VGA 720x400
SVGA 800x600
XGA 1024x768
WXGA 1280x768
WXGA 1280x720
To return to normal mode
Press INPUT SELECT again.
Refresh rate
60Hz
70Hz
60Hz
60Hz
60Hz
60Hz