Verify Anti-Tip Bracket Is Installed And Engaged; Electronic Ignition System - Kenmore W11123999C Installation Instructions Manual

E
A. Burner cap
B. Gas tube opening
C. Burner base
6. Place the burner caps on the appropriate burner
bases.
IMPORTANT: The bottom of the small and medium caps
are different. Do not put the wrong size burner cap on
the burner base. Each round burner cap is marked with
an S, M, L, or XL to match with a letter on the burner
base.
M
S
Small cap Medium cap
Burner caps should be level when properly positioned. If
burner caps are not properly positioned, surface burners
will not light. The burner cap should not rock or wobble
when properly aligned.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
7. Plug into a grounded 3 prong outlet.
A
B
C
D
D. Igniter electrode
E. Orifice holder
XL
L
Large cap X-Large cap
A
B
A. Incorrect
B. Correct
Verify Anti-Tip Bracket
Is Installed and Engaged
1. Slide range into final location, making sure rear leveling
leg slides into anti-tip bracket.
2. Remove the storage drawer. See the "Remove/Replace
Drawer" section.
3. Use a flashlight to look underneath the bottom of
the range.
4. Visually check that the rear range foot is inserted into
the slot of the anti-tip bracket.

Electronic Ignition System

Initial Lighting and Gas Flame Adjustments
Cooktop and oven burners use electronic igniters in place of
standing pilots. When the cooktop control knob is turned to
the Lite position, the system creates a spark to light the burner.
All cooktop burners will spark, but only the burner with the
control knob turned to the Lite position will produce a flame.
This sparking continues as long as the control knob is turned
to the Lite position.
When the oven control is turned to the desired setting,
sparking occurs and ignites the gas.
Check Operation of Cooktop Burners
Standard Surface Burners
Push in and turn each control knob to the Lite position.
The flame should light within 4 seconds. The first time a burner
is lit, it may take longer than 4 seconds to light because of air
in the gas line.
If Burners Do Not Light Properly:
Turn cooktop control knob to the Off position.
■
Check that the range is plugged into a grounded 3 prong
■
outlet. Check that the circuit breaker has not tripped or
the household fuse has not blown.
Check that the gas shut-off valves are set to the open
■
position.
Check that burner caps are properly positioned on burner
■
bases.
Repeat startup. If a burner does not light at this point, turn the
control knobs to the Off position and contact your dealer or
authorized service company for assistance. Please reference
the back cover of the Use & Care Guide to contact service.
If the cooktop low burner flame needs to be adjusted for any
of the burners, see the "Adjust Flame Height" section.
11