Clickpad Cable - HP 15-BQ0 Series Maintenance And Service Manual

ClickPad cable

NOTE: The ClickPad spare part kit does not include the ClickPad cable. The ClickPad cable is available using
spare part number 924351-001.
Before removing the ClickPad cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the ClickPad cable:
1. Release the ZIF connector (1) to which ClickPad cable is connected, and then disconnect
the ClickPad cable from the system board.
2. Release the ZIF connector (2) to which ClickPad cable is connected, and then disconnect
the ClickPad cable from the ClickPad.
3. Detach the ClickPad cable (3) from the keyboard/top cover. (The ClickPad cable is attached to
the keyboard/top cover with double-sided adhesive.)
4. Remove the ClickPad cable.
Reverse this procedure to install the ClickPad cable.
Bottom cover on page
Battery on page 31).
29).
Component replacement procedures 39