Double espresso GrinDer K30 TWIN 2.0 (HYBRID) Contents Overview ......2 Changing settings ....25 Display/navigation symbols ..25 Included in delivery ..... 9 Retrieving and leaving General information ..10 main menu ........26 Read operating instructions Unlocking service menu ..... 26 and keep safe ......
European Union. Please also note the guidelines and laws of your specific country if abroad. For better clarity, the Double Espresso Grinder K30 TWIN 2.0 (HYBRID) shall be referred to hereinafter simply as the “grinder”. Please keep this original instruction manual safe for later queries.
Page 11
K30 TWin 2.0 (HYbriD) | en This symbol provides you with important information concerning operation or handling. Conformity declaration (see chapter “Conformity declaration”): Products marked with this symbol fulfil all applicable community provisions of the European Economic Area. ETL Listed seal of approval: Products marked with this symbol meet the requirements for electrical product safety of the United States of America.
Double espresso GrinDer Safety Intended use The grinder is only suitable for grinding whole roast coffee beans. Do not use the grinder to grind other products or objects. It is intended for commercial use and may only be serviced by trained personnel. It may, however, be operated by other persons in a place where use is supervised.
Page 13
K30 TWin 2.0 (HYbriD) | en – Install the grinder only in places where the handling of the grinder can be supervised by trained personnel. – Do not immerse the grinder or the power cable / power plug in water or any other liquids.
Page 14
Double espresso GrinDer WARNING! Danger for children and persons with reduced physical, sensory and mental abilities (e.g. partially disabled persons, older persons with limited physical and mental abilities) or a lack of experience and knowledge (e.g. older children). – This grinder may be used by children older than eight years and by persons with reduced physical, sensory or mental disabilities or a lack of experience and knowledge if they are supervised or instructed on the safe use of the grinder and have understood...
Before using Functioning and basic settings The grinder models K30 TWIN 2.0 and K30 TWIN 2.0 HYBRID each have two grinders that can be controlled separately (left and right). The shot sizes, i.e. the volume of grounds per withdrawal, are defined by the grinding time.
Double espresso GrinDer Checking grinder and scope of delivery INFORMATION! Risk of damage! The grinder can become damaged if the packaging is opened carelessly with a sharp knife or other pointed object. – Be very careful when opening. 1. Remove the grinder from its packaging. 2.
Page 17
K30 TWin 2.0 (HYbriD) | en For grinders designed for mains voltage ranges of 200–230 V or 220–240 V, the locking screw for the bean container is a hexagon socket screw. Use the 2 mm Allen key supplied with this model to fix the bean container.
Double espresso GrinDer 9. Place the drip tray (13) into the corresponding opening under the outlet (6) so that the magnets underneath the drip tray sit in the appropriate intakes. Connecting the potential equalizer The connection for potential equalization (19) is located on the back of the grinder (see Fig.
K30 TWin 2.0 (HYbriD) | en Adjusting the portafilter support and attaching the container intake For grinders designed for mains voltage ranges of 200–230 V or 220–240 V, the portafilter support and the container intake are attached with hexagon socket screws. Use the 3 mm Allen key supplied with this model for fixing.
Double espresso GrinDer Operation INFORMATION! Danger of overheating! Exceeding the maximum permissible operating cycle can cause the grinder to overheat. – Do not exceed the maximum operating cycle (see chapter “Technical data”). – Observe the recommended pause when the maximum permis- sible operating cycle is reached (see chapter Technical data “...
K30 TWin 2.0 (HYbriD) | en Switching on the grinder 1. Make sure that you have inserted the power plug (20) into a properly installed safety socket. 2. Switch on the grinder by switching the On/Off switch (21) to “I”. The grinder is ready for operation as soon as the recipes last selected / the symbol for manual grinding appear(s) on the display (14).
K30 TWin 2.0 (HYbriD) | en Grinding coffee beans Grinding according to a recipe (recipe mode) 1. On the display (14), swipe over the display range on the respective grinder (left/right) to select the desired recipe (see chapter “Selecting the recipe/grinding time”).
Double espresso GrinDer Interrupting grinding (stop function) The stop function automatically suspends grinding when you remove the portafilter from the portafilter intake(7) and continues grinding when you insert the portafilter into the portafilter intake again and trigger the start button (9). 1.
K30 TWin 2.0 (HYbriD) | en Changing settings You can retrieve appliance data and change the settings in the main menu. If you take longer than 3 minutes to make or confirm a selection in the main menu or in a sub-menu, you will automatically be taken back to the home screen.
Double espresso GrinDer Recipe symbols for grinding on the portafilter space Recipe symbols for grinding on the container space Retrieving and leaving main menu symbol on the display (14) to go to the main menu. – Click on the – Click on the symbol on the display to go back one level in the main menu.
K30 TWin 2.0 (HYbriD) | en Retrieving service menu Only a service technician can access the service menu. 1. Go to the main menu (see chapter “Retrieving and leaving main menu”). 2. Unlock the service menu if necessary (see chapter “Unlocking service menu”).
Double espresso GrinDer 7. Click on the symbol to confirm the selection. You will be taken to the input option for the grinding time. 8. Set the desired grinding time by swiping up/down over the appropriate areas on the time display. 9.
Page 29
K30 TWin 2.0 (HYbriD) | en Displaying/editing default grinder settings 1. Go to the service menu (see chapter “Retrieving service menu”). 2. Swipe up/down on the display (14) and select the menu item “Default grinder settings”. 3. Swipe up/down on the display and select the desired menu item by clicking on it.
Page 30
Double espresso GrinDer Resetting day counter 1. Go to the service menu (see chapter “Retrieving service menu”). 2. Swipe up/down on the display (14) and select the menu item “Reset day counter”. 3. Confirm the reset of the day counter by clicking on the symbol, or click on the symbol to cancel the process.
K30 TWin 2.0 (HYbriD) | en Confirming service performed 1. Go to the service menu (see chapter “Retrieving service menu”). 2. Swipe up/down on the display (14) and select the menu item “Confirm service performed”. 3. Confirm that the service measures were carried out in full by clicking on symbol, or click on the symbol to cancel the process.
Double espresso GrinDer Cleaning CAUTION! Risk of injury! The grinder can fall over when moved and cause injury. – Place the grinder on a stable, tilt-proof surface. – Ask another person for help if the grinder is too heavy. INFORMATION! Risk of short-circuit! Water penetrating the grinder can cause a short-circuit.
K30 TWin 2.0 (HYbriD) | en Cleaning the grinder installation surface 1. Switch off the grinder (On/Off switch (21) to “0”) and remove the power plug (20) from the socket. 2. Lift the grinder by the casing with both hands and place onto a clean surface.
Double espresso GrinDer 3. Remove any remaining coffee beans from the bean container and pour these into another container for temporary storage. 4. Spray the bean container inside and out a few times with bean container cleaner. 5. Clean the bean container inside and out with a cloth and then dry the bean container.
K30 TWin 2.0 (HYbriD) | en Troubleshooting Error Cause Remedy The grinder is • The outlet is t Set the grinding degree adjustor to humming but clogged. “8” and trigger the grinding process. not grinding. The grinder will grind itself clear.
Page 36
Double espresso GrinDer Error Cause Remedy The grinder is • The power plug t Insert the mains plug into a properly not grinding, is not plugged installed wall socket. the display is into a socket. not lit up. • The overcur- t Contact your supplier (see chapter rent protection “Maintenance and service”).
Page 37
K30 TWin 2.0 (HYbriD) | en Error Cause Remedy The grinder’s • The outlet is t Clean the outlet from the outside dosing accura- clogged. with the brush whilst the grinder cy is decreas- Too much is switched off. Set the grinding ing.
K30 TWin 2.0 (HYbriD) | en Disposal Disposing of the packaging Dispose of the packaging by correctly sorting the recyclable materials. Dispose of card and cardboard as waste paper, and film as recyclable materials. Disposing of the grinder Old appliances may not be thrown into commercial/domestic waste!
Product: Device for food processing Machine model: Coffee grinder Type of machine: K30 TWIN, K30 TWIN 2.0, K30 TWIN 2.0 Hybrid Following directives, regulations and standards have been applied: 2006/42/EG The provisions of the Machinery Directive 2014/35/EU The Low Voltage Directive...
Need help?
Do you have a question about the K30 TWIN 2.0 and is the answer not in the manual?
Questions and answers