Bazooka Phat Tuesday MGA11000H Installation Manual page 16

R
Before connecting the remote, it will be necessary to find a mounting location that will be
easy to access for adjustment. Once you select your mounting location, you will need to
run the control wire from the remote to the amplifier.
noise from the car's electrical system (i.e. popping noises or engine noise), run the cable
from the remote to the amplifier away from the car's electrical wiring.
The MGA11000H and MGA11500H are equipped with diagnostic lighting to display the operation
status of the amplifier. The following shows the lighting mode and the description of the
amplifier's condition.
Top Light On and Blue Power LED On = Amplifier is running normally.
Top Light On and end Panel Lights are Alternating between Red and Blue = Amplifier is in thermal protection.
Top Light Blinking Slowly and Red Power light Blinking out of synch with Top Light = Over Voltage Reduce the
input Voltage.
Top Light Blinking Quickly and Red Panel Light Blinking in Synch with Top Light = Short Circuit Protection.
Top Light and Red panel Light Blinking Three (3) times with a pause = Repeated shorts are detected. Remove
short circuit and wait 5 minutes for this error condition to clear. The condition can also be cleared by
removing the main power, for example pulling the fuse.
EMOTE BASS CONTROL MODULE
SUBSONIC XOVER
REMOTE
PHASE
FREQ Hz FREQ Hz
30
10
IN
OUT
80
250
BASS
BOOST
30 0
MIN
dB
125 15 MAX
FREQ Hz BASS BOOST GAIN
D
IAGNOSTIC LIGHTING
To avoid possibility of induced
SOURCE
SLAVE IN INPUT
PWR \
NORMAL
PROT
L
SLAVE
L R
+ - + -
R
SPEAKER
LEVEL IN
.4V - 12.2V
SLAVE OUT
15