Bartec TC75ex-NI Quick Start Manual

ex FEATURES
TC75 NI
-
QUICK START
Note: Remove protective shipping film that covers the touch screen, exit
window and camera window before using.
GUIDE
11
12
13
14
15
1
2
3
4
1 Scan Button
2 PTT Button (programmable)
3 Back Button
4 Home Button
5 Power Input
6 Search Button
7 Menu Button
Note 1: To reset the TC75, press and hold the Power button until the menu
appears and then select Reset.
23
10
16
9
17
18
8
22
19
7
6
20 21
16 Hand Strap Mounting Point
20 Exit Window
17 Rear-facing Camera
21 Volume Button
18 Camera Flash 22 Battery Release Latch
19 Interface Connector 23 Hand Strap
5
Notifications
8 Touch Screen
Data Capture LED:
9 Light Sensor Green: Good Decode
Charging/Notification
10 Proximity Sensor Red: Data capture in process
Blue: Application notification
11 Power Button Data Capture
12 Receiver
Charging\Notification LED:
13 Charging/Notification LED
Slow blinking amber: Battery charging
14 Data Capture LED
Solid green: Fully charged
15 Front-facing Camera
Fast blinking amber: Charging error
Slow blinking red: Charging aged battery
Solid red: Fully charged aged battery
Fast blinking red: Charging error aged battery
Slow blinking blue: Application notification
SIM/SAM/SD CARD INSTALLATION SECURITY & EX
WARNINGS
1. Lift the access door.
DANGER describes a directly imminent danger in hazardous
areas. If not avoided, death or severe injury will be the
consequence.
Unintended use endangers explosion protection. Risk of
fatal injury in an explosive atmosphere! In the case of
2. Insert the SIM/SAM/microSD card into the card holder. Push the card all the
functional disturbances or damage to the enclosure, the
way into the card holder.
device should be turned off and removed immediately from
NOTE:
the potentially explosive atmosphere to a safe place.
Proper position of the SIM/SAM/microSD card - the card connector (i.e., gold contacts)
should be facing down. Nano slot 1 is default slot for SIM card. Go to Settings to
Do not replace or charge the battery in a potentially
configure the default SIM slot, if enabled by your system administrator.
explosive atmosphere.Danger to life in a potentially explo-
sive atmosphere! Only replace or charge the battery
Nano SIM Card
SIM or SAM Card outside the potentially explosive atmosphere.
Remove battery to decommission the device! The ambient
temperature range of use for secure operation within the
potentially explosive atmosphere is -20 °C to +50 °C.
Nano Slot 1 Nano Slot 2
Additional safety instructions for use in potentially
(default)
explosive atmospheres, see user manual.
microSD Card
Only insert or replace the SIM/Micro SD card outside of the
potentially explosive atmosphere. Only use micro SD cards
which have been tested and certified by BARTEC for this
purpose.
3. Replace the access door.
Ensure that it is properly seated.
HANDSTRAP AND BATTERY INSTALLATION
1. Remove hand strap filler plate. 4. Rotate the battery down into the battery compartment and press the
battery down until it snaps into position.
2. Insert the hand strap plate into the handstrap slot.
5. Place the hand strap clip into the hand strap attachment slot and pull
down to lock into place.
3. Insert the bottom of the battery into the battery compartment.
6. Lift the hand strap ribbon off the hook material.
7.
Slide the pad and adjust the ribbon for best fit.
8. Press the ribbon down to secure to hand strap.