Maintenance - AEG AFNDA18 Original Instructions Manual

Table of Contents

Advertisement

DRIvE DEPTH ADjUSTmENT
See figure 9.
The driving depth of the nail may be adjusted by rotating the
dial clockwise to increase or counterclockwise to decrease
the depth the nail is driven. It is advisable to test the depth
on a scrap workpiece to determine the required depth for the
application and to drive a test nail after each adjustment until
the desired depth is set.
REmOvING NAIlS FROm THE TOOl
See figure 10.
■ Remove the battery pack from the tool.
WARNING!
Remove the battery pack from the tool before removing nails.
Failure to do so could result in serious personal injury.
■ To remove a strip of nails from the tool, hold the finish nailer
by the handle with your right hand, and rest your left hand
underneath the tool with your left thumb on the pusher.
■ Depress the inside lever on the pusher to release and allow
the pusher to slowly slide to the front.
NOTE: Always keep fingers clear of nail track of magazine
to prevent injury from unintended release of the pusher.
■ Slide the nails toward the back of the magazine and
remove.
ClEARING A jAmmED FASTENER
See figure 11.
WARNING!
■ Remove the battery pack from the tool before clearing a
jammed fastener. Failure to do so could result in serious
personal injury.
If a nail or fastener becomes jammed in the tool, remove the
battery pack and keep the tool pointed away from you while
clearing the jam.
■ Remove the battery pack from the tool.
■ Remove fasteners from the tool.
■ Pull up on the latch and open the jam release.
■ Insert a flat blade screwdriver into the driving mechanism
and push the driver mechanism back, freeing the fastener
jam.
■ Remove the bent fastener.
■ Close the jam release and latch.
■ Reinstall the battery pack.
■ Reinstall fasteners and close the magazine.

mAINTENANCE

Use only AEG accessories and spare parts. Should
components need to be replaced which have not been
described, please contact one of our AEG service agents (see
our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the Article No. as well as the machine type printed on
the label and order the drawing at your local service agents or
directly at: AEG Electric Tools, Max-Eyth-Straße 10, D-71364
Winnenden, Germany.
10
SymbOlS
Please read the instructions carefully before
starting the machine.
Remove the battery pack before starting any
work on the machine.
Do not dispose of electric tools together with
household waste material! In observance of
European Directive 2002/96/EC on waste
electrical and electronic equipment and its
implementation in accordance with national
law, electric tools that have reached the end
of their life must be collected separately and
returned to an environmentally compatible
recycling facility.
10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents