Samsung WF520 User Manual page 21

Select Cycle
6
Option
Start/Pause
7
selection button
Power button
8
WF520AB-02838A_EN.indd 21
Press these buttons to select different cycle options.
Pre Wash - To use this feature, add detergent to the pre wash section of the
detergent compartment. When turned on, the washer fills with cold water and
detergent, tumbles, then drains and advances to the selected wash cycle.
Some cycles cannot be selected with with this option (See pages 27~28).
You cannot select the prewash option in the Delicate, Wool, Quick
Wash, Delicates/Handwash, Rinse+Spin, and Spin Only cycles.
Extra Rinse - Add an additional rinse at the end of the cycle to more
thoroughly remove laundry additives and perfumes.
Extended Spin - Add additional time to remove more water from loads.
Signal On/Off - Press the Signal button to turn the signal (chime) on or off.
My Cycle - Choose your favorite cycle including temperature, spin, soil level,
option, etc.
Delay Start - Any cycle can be delayed for up to 24 hours in one-hour
increments. Displayed hour indicates the time at which the wash will be started.
Pure Cycle - Use to clean dirt and bacteria from the drum. Regular use
TM
(after every 40 washes) is recommended. No detergent or bleach is needed
(see page 33).
Steam - Press this button to use the Steam Wash function. Steam Wash is
available with Heavy Duty, Normal, Perm Press, Sanitize, Bedding cycles. For
heavily soiled, colorfast garments, Steam Wash improves stain treatment and
uses less water (See page 25).
Press to pause and restart programs.
Press once to turn your washer on, press again to turn your washer off. If
the washer is left on for more than 10 minutes without any buttons being
touched, the power automatically turns off.
washing a load of laundry _21
2010-03-24 ¿ÀÈÄ 4:30:29