NEC Express5800 Series User Manual page 88

Chapter 2 Preparations
5. Attach the RAID controller bracket to the
RAID controller with two screws removed in
step 3.
6. Insert the RAID controller slightly into the
dedicated slot while tilting the card.
7. Gently place the RAID controller on bottom
plate of chassis so that it becomes horizontal
to the motherboard.
8. Insert the RAID controller into the slot while
keeping horizontal state.
9. Secure the RAID controller bracket with two screws removed in step 4.
10. Disconnect SAS/SATA cable from SATA connector on motherboard.
11. Perform the following according to the number of hard disk drive connected.
− Four or less hard disk drives are installed:
Connect SAS/SATA cable removed in step 10 to connector (Ports 0-3) on RAID controller.
− Five or more hard disk drives are installed:
Connect SAS/SATA cable removed in Step 10 to connector (Ports 0-3) on RAID controller.
Connect SAS/SATA cable provided with the server to connector (Ports 4-7) on RAID controller.
Remove one screw from server chassis, and remove battery tray for RAID controller.
Connect another end of SAS/SATA cable that has been connected to connector (Ports 4-7) on
RAID controller, to the connector on backplane.
Secure the battery tray for RAID controller with one screw.
12. Continue to install or remove internal options, mount and connect the server, and turn it on.
(2)
Using optional RAID controller (N8103-179)
See Chapter 2 (1.10.4 Installing FBU).
88
Express5800/R120f-1E User's Guide
1. Installing Internal Options
Ports 4-7
Ports 0-3