3 Getting Started
Install and Charge the Battery Pack
Open the battery cover by gently pressing down on the top of the cover while sliding it down.
Plug the battery pack into the battery compartment and close the compartment.
* Place the handset in the base station to charge for 14 hours prior for first use. If you don't properly
charge the phone, battery performance will be compromised.
4 Basic Telephone Operation
Power on operation
The handset is powered by plugging a battery or by putting on cradle. After then, it will begin to
search for a base station that has been registered to that handset. The 'Aerial' icon will flash and
"RANGE OUT" is shown during searching.
After several second, the LCD will display "XX NEW CALLS" if there are new calls existing or
show the handset number and the handset name.
Making external calls
Normal dialing
Press [ ] and the 'Phone' icon will be on. If handset is not subscribed or out of range, [ ] key
cannot be used and pressing it will bring on an error tone.
The 'EXT' icon will be on after the PSTN line is connected. (In case that one handset is connected
with the PSTN line, the 'EXT' icon on the other handset will also be on indicating that the line is
engaged.)
Dial the number as required.
EXT
2 9 5 1
Press [R/
] to flash the line to perform some PABX function and the LCD will be cleared waiting
for new input. The number dialed after the 'Flash' will not be stored in the redial memory.
If call timer has been set to ON, then after 8 seconds of no further key press, the call timer counter
8