Putting The Batteries In The Remote Control; Using The Remote Control - Pioneer DVR-RT500 Operating Instructions Manual

Dvd recorder &vrc
Hide thumbs Also See for DVR-RT500:
Table of Contents

Advertisement

Controls and displays
02
Putting the batteries in the remote
control
1
Open the battery compartment cover on the back of
the remote control.
2
Insert two AA/R6P batteries into the battery
compartment following the indications (+,*) inside the
compartment.
3
Close the cover.
Note
Incorrect use of batteries can result in hazards such as
leakage and bursting. Please observe the following:
• Don't mix new and old batteries together.
• Don't use different kinds of battery together-
although they may look similar, different batteries
may have different voltages.
• Make sure that the plus and minus ends of each
battery match the indications in the battery
compartment.
• Remove batteries from equipment that isn't going
to be used for a month or more.
• Do not try to recharge batteries not intended to be
recharged; they can overheat ant rupture. (Follow
battery manufacturer's directions.)
• When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction's rules that apply in your country
or area.
14
En
VRB1351A_EN_11_21
14

Using the remote control

Keep in mind the following when using the remote
control:
• Make sure that there are no obstacles between the
remote and the remote sensor on the unit.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the unit's
remote sensor.
• Remote controllers for different devices can
interfere with each other. Avoid using remotes for
other equipment located close to this unit.
• Replace the batteries when you notice a fall off in
the operating range of the remote.
• Use within the operating range and angle, as
shown.
30
30
15ft
04.6.14, 10:26 AM

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dvr-rt300

Table of Contents