Scale Menus (1 And 2) - Honeywell 301C User Manual

Scale Menus (1 and 2)

These menus appear only for certain devices. Scale(1) allows the
detection range, minimum and maximum, to be defined for the
selected device. Whatever value is specified is the value that will
appear at the device display (if applicable). The Minimum value is
generally left at 0. Parameters for the XNX and XCD gas detectors can
be viewed here but can be changed only at the transmitter.
Scale(2) allows the factor by which to divide the scale (between 0 and
65535) and the unit of measurement for the selected scale to be
determined.
The factor allows precise scale limits for detection to be set. By
dividing the maximum scale value in the first Scale screen (250 in this
example) by 10, a scale value of 25.0 can then be displayed.
The "Units" allow the device's unit of measurement to be selected:
°F: Sets degree Farenheit as the unit of measurement
°C Sets degree Centigrade as the unit of measurement
%RH Sets Relative Humidity as the unit of measurement
mV Sets millivolts as the unit of measurement
V Sets volts as the unit of measurement
mA Sets milliamps as the unit of measurement
% Sets the percentage of gas as the point unit of measurement
ppm Sets parts per million of gas as the point unit of
measurement
27