Table of Contents
Advertisement
Setting the Speaker Mode
Before moving or installing the product, be sure to turn off the power and disconnect the power cord.Signal outputs
and frequency response from the speaker will automatically be adjusted according to your speaker configuration
and whether certain speakers are used or not.
REMOTE CONTROL
1
2
To Exit Setup Mode
Wait for about 5 seconds or press the SPK SEL. button of the remote control to
•
select SPK MODE OFF.
To turn the SUBWOOFER On or Off.
Press SUBWOOFER button.
•
Each time you press this button, SW SPK : YES, SW SPK : NO will be selected in turn.
If you play in 2 Channel Stereo, select 'YES' to use Subwoofer and 'NO' not to use.
•
19
√
Press SPK SEL. button to select the speaker you want.
Each time you press this button, F.SPK
C.SPK
S.SPK
•
CROVR
SPK MODE OFF will be selected in turn.
Press ...† button to set the speaker mode.
If F.SPK is set to 'SMALL', SW SPK is fixed to 'YES'.
•
SW SPK
Setting the Speaker
• F.SPK (Front) : LARGE, SMALL
• C.SPK (Center) : LARGE, SMALL, NONE
• S.SPK (Surround) : LARGE, SMALL, NONE
• SW SPK (Subwoofer) : YES, NO
• CROVR (Crossover Frequency): 60, 80, 100, 120, 150, 180, 200Hz
MAIN UNIT
1
Press SETUP button.
•
"SETUP MODE" appears on the display and enters into Setup Mode.
2
Press INPUT button one time.
•
"SPEAKER SETUP" appears in the display.
3
Press SURROUND button to select the speaker you want.
•
Each time you press this button, F.SPK
C.SPK
S.SPK
CROVR will be selected in turn.
4
Press SELECT (
) button to set the speaker mode.
,
To Exit Setup Mode
Wait for about 5 seconds or turn the VOLUME CONTROL of the main unit.
•
"SETUP MODE OFF" appears on the display and exits Setup Mode.
• LARGE : Select when you use large speaker. You can listen to full
range sound.
• SMALL : Select this when you use small speaker.
Bass below 100Hz will not be output.
• NONE : Select this when you use no speaker.
• YES : Select this when you use Subwoofer Speaker if you play
back in 2 Channel Stereo.
• NO : Select when you do not use Subwoofer Speaker if you play
back in 2 Channel Stereo.
• CROVR: Select the crossover frequency depending on the size of
speaker connected when you use subwoofer.
Select 60Hz if cone paper speaker is 5.6inch, select 80Hz
for 4.8inch, 100Hz for 4inch, 120Hz for 3.2inch, 150Hz for
2.4inch, 180Hz and 200Hz for 1.6inch.
SW SPK
20
Advertisement
Table of Contents
