Diamond X Collection |
III. STEP-by-STEP INSTALLATION
Step 2: Using a screw driver remove top mirror panel by unscrewing bolts on each side.
Step 3: Remove bulb to gain access to fixing holes.
Using level make sure cabinet is horizontal and mark the fixing holes.
Step 6: Pull 240 volt cable through rear grommet on rear of cabinet and fix cabinet to wall.
Note: Please leave a minimum of 10cm between sensor head on side of frame and the nearest
obstacle e.g. a wall, another cabinet, etc., as the sensor will not be able to work properly.
Model: 100877K5 & K6