Before Calling for Service
Symptom
Can't turn it on.
It does not work when the
button is pressed.
Sound is not produced.
Picture does not appear when
the function is selected.
Remote controller does
not work.
The sound from each
device is changed during
stereo playback.
Can't receive
broadcasting.
There is no sound from
surround speaker.
There is no sound from
center speaker
46
Check
Is the power code plugged into the outlet?
•
Is there static electricity in the air?
•
Are the speaker and external
•
component connected properly?
Does the Mute function work?
•
Is the volume set to minimum?
•
Is the speaker setup selected to
•
NONE?
Isn't the external component connected
•
properly?
Are the batteries exhausted?
•
Is the distance between remote
•
control and main unit proper?
Is the left/right speaker or left/right
•
input/output code connected
properly?
Is AM or FM antenna connected
•
properly?
Is the surround speaker connected
•
properly?
Is S.SPK (Surround) set to NONE in
•
Speaker Setup?
Is Surround Mode selected to Stereo?
•
Is the center speaker connected properly?
•
Is C.SPK (Center) selected to NONE in
•
Speaker Setup?
Is the Surround Mode selected to Stereo?
•
Remedy
Connect the power plug to the outlet.
•
Disconnect the power plug and connect it
•
again.
Properly connect it.
•
Press Mute button to cancel the function.
•
Adjust the volume.
•
Refer to pages 20~21 to select LARGE,
•
SMALL or YES.
Properly connect it.
•
Replace with new batteries.
•
Operate at close distance.
•
Check the left/right channel and properly
•
connect it.
Properly connect the antenna.
•
If the input strength of antenna connector
•
is weak, install the FM antenna in a place
with good reception.
Refer to pages 10~11 to connect it properly.
•
Refer to pages
to select LARGE or
20~21
•
SMALL.
Refer to pages 30~37 to select other
•
Surround Mode.
Refer to pages 10~11 to connect it properly.
•
Refer to pages
20~21
to select LARGE or
•
SMALL.
Refer to pages 30~37 to select other
•
Surround Modes.