Dc Power Cable Installation - Motorola Cleartone CM5000 Installation Manual

INSTALLATION

DC Power Cable Installation

Installation Planning
The 3 meters (10 feet) DC power cable shipped with the terminal should be long enough to be
installed in most vehicles. Take the following precautions before you begin:
1. Whenever possible, avoid routing the cable above the catalytic converter.
2. Make sure that the power cable never rests on sharp edges.
3. Use grommets whenever a cable has to pass through a hole in a metal panel.
The following table lists power cables available for this terminal:
Number Description
GKN6270 Power Cable to battery with fuse 10A
GKN6274 Power Cable to battery with fuse 10A
HKN9327 * Ignition Sense Cable with fuse 4A
6500139767 Fuse 10A for Power Cable
6580283E02 * Fuse 4A for Ignition Sense Cable
* For more information refer to section "Ignition Sense Cable". The Ignition Sense Cable allows the
terminal to be turned on and off by the vehicle ignition switch.
CM5000 TETRA Mobile Repeater/Gateway Installation Manual
Table 1 DC Power Cables
This terminal must be operated only in negative ground
electrical systems. Operating the terminal on a positive
ground system will cause the cable fuse to short-circuit.
Check the vehicle ground polarity before you begin the
installation.
Rating
12V Power Cable to Battery, Length: 3 m
12V Power Cable to Battery, Length: 6 m
Ignition Sense Cable, Length: 3 m
In case of blown fuses, replace ONLY with those of identi-
cal value.
NEVER insert ones of different values.
23