Installing An Mda - Bay Networks BayStack 303 User Manual

Using the BayStack 303 and 304 Ethernet Switches
Table B-2.
Label
Link
100
F Dx

Installing an MDA

The expansion slot on the BayStack 303 or 304 switch accommodates a small
media dependent adapter that provides one high-speed port connection. The
connection can be either an RJ-45 10/100BASE-TX MDA or a fiber
100BASE-FX MDA with an SC connector.
To install an MDA into the expansion slot, follow these steps:
Warning: The switch must be taken offline and have all power removed prior
to installing the MDA. Failure to remove power can result in damage to
sensitive components and void all equipment warranties.
1.
2.
B-4
100BASE-TX MDA LEDs
Color State
Green On
Off
Green On
Off
Green On
Off
Unplug the AC power cord from the back of the switch.
Remove the filler panel over the expansion slot.
Meaning
Link is active and connected correctly.
Link is inoperative or improperly connected.
Port is operating at 100 Mb/s.
Port is operating at 10 Mb/s.
Port is operating in full-duplex mode (200 Mb/s).
Port is operating in half-duplex mode (100 Mb/s).
893-01010-A