Advertisement
Chapter 2
Assembling the Cisco TelePresence System TX1300 47—Freestanding Version
c.
d.
Note
Figure 2-5
Attaching the End Caps and Light Reflector to the Cabinet and Removing the Protective Paper
OL-24695-01
Route the cables for the display (found with the display in box #4) through the slot in the lower
center area of the reflector and the notch at the top of the cabinet.
Remove the protective paper from the outside of the light reflector.
Alternatively, you can remove the paper before you install the light reflector.
a
Cisco TelePresence System TX1300 47 Installation, First-Time Setup, and Field-Replaceable Unit Guide
b
c
Assembling the TX1300 47
d
2-7
Advertisement
