Advertisement
Assembling the TX1300 47
Step 4
Remove the light reflector from its plywood backing by removing four screws, indicated by yellow
arrows on the light reflector. Use the handles to lift the light reflector away from the plywood backing
as shown in
Figure 2-4
Attach the cabinet post end caps and the light reflector:
Step 5
Attach the end caps to the tops of the cabinet posts. See callout a in
a.
The end caps are in the accessory kit.
Attach the light reflector to the cabinet.by hanging it on the two round pegs on the cabinet posts, and
b.
then screwing it to the cabinet posts using four screws (P/N 69-2181-01) and a #3 Phillips
screwdriver, and attaching the bottom of the light reflector to the cabinet using two screws (P/N
69-2179-01) and a #2 Phillips screwdriver.
Note
Cisco TelePresence System TX1300 47 Installation, First-Time Setup, and Field-Replaceable Unit Guide
2-6
Chapter 2
Figure
2-4.
Removing the Light Reflector from Its Packaging
If using a power drill/screwdriver, set the torque to a setting of 5, 6, or 7.
Assembling the Cisco TelePresence System TX1300 47—Freestanding Version
Figure 2-5
for more information.
OL-24695-01
Advertisement
