Download Print this page

Cisco TX1300 47 Manual page 12

Telepresence system, freestanding version

Advertisement

Assembling the TX1300 47
Step 10
Insert the codec into the cabinet:
Use the diagram in
a.
flags with icons that represent the connections; use these tape flags to connect the light and
microphone cables. These cables must be installed before the coded is installed.
Note
Note
Retrieve the codec brackets and eight attachment screws (P?N 69-2175-01) from the accessory kit.
b.
Attach the codec brackets to the codec, using four screws on each side. See
c.
information.
Insert the codec and brackets into the left side of the cabinet and attach the codec assembly to the
d.
bottom of the cabinet using two screws (P/N 69-2274-01). See
Use the diagram in
e.
icons that represent the connections; use these tape flags to connect the cables.
Note
Note
Cisco TelePresence System TX1300 47 Installation, First-Time Setup, and Field-Replaceable Unit Guide
2-12
Chapter 2
Figure 2-12
The lights are numbered. Light #1 is the top light, light #2 the bottom light, light #3 the left light,
and light #4 is the right light.
There are three different places in the cabinet where cables are tied to the cabinet with cable ties
to prevent damage during shipping. Cut these cable ties to release the cables before connecting
them.
Figure 2-12
Route the external power cable through a rectangular cutout at the rear of the cabinet. Route the
external microphone and VGA cables route into the cabinet through a slot at the bottom of the
cabinet. See
Figure 2-13
for more information.
The audio connection for the presentation cable on the codec is different based on the cable you
use for presentations. If you use a VGA-to-VGA cable, use the audio connection on the codec
labeled with an icon of a computer. If you use a HGMI-to-HDMI, HDMI-to-DisplayPort, or
HDMI-to-Mini Displayport cable, use the audio connection labeled "Aux" on the codec.
Figure 2-12
shows both connections.
Assembling the Cisco TelePresence System TX1300 47—Freestanding Version
to connect the light and microphone cables. The cables have tape
to connect the remaining cables. The cables have tape flags with
Figure 2-10
for more
Figure 2-11
for more information.
OL-24695-01

Advertisement

loading