TP-Link Archer C7 Quick Installation Manual

Quick Installation Guide

Wireless Dual Band Router
* Images may differ from actual products.
1 Connect the Hardware
If your internet is from an Ethernet outlet, connect the router's
Internet port to the Ethernet outlet, then follow Step 4 and 5.
If you already have a router and want to configure this new router
as an access point to extend your network, refer to the Access
Point Mode section on the back page.
Internet
Power adapter
Modem
Power adapter
Router
1
Turn off the modem, and
remove the backup
battery if it has one.
2
Connect the modem to the
router's Internet port with an
Ethernet cable.
3
Turn on the modem, and
then wait about 2 minutes
for it to restart.
Internet
Power
4
Connect the power
adapter to the router and
turn on the router.
5
Verify that the following LEDs are solid on to
confirm the hardware is connected correctly.
Power 2.4GHz 5GHz
On On On On (Green or Orange)
Note: If the 2.4GHz LED and 5GHz LED are off, press and hold the
WPS/Wi-Fi button on the back for more than 2 seconds. Both the
LEDs should turn solid on.
On / Off
Internet