Advertisement
When relamping, only use lamps specified in the exit sign. Using other lamp types may result in unsafe conditions.
Battery in the unit may not be fully charged. After electricity is hooked up to unit, let the battery charge up for at least
24 hrs. The normal operation of the unit should take effect.
PLEASE READ CAREFULLY AND FOLLOW ALL INSTRUCTIONS FOR YOUR SAFETY
1.
All electrical connections must be in accordance with local codes, ordinances and the National
Electric code.
2. Do not use outdoors.
3. Do not mount near gas or electric heater.
4. Equipment should be mounted in location and at heights (Max: 7ft) where it will not be readily subjected to
tampering by unauthorized personnel.
5. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
6. Use caution when handling batteries.
7. Do not use this equipment for anything other than the intended use.
8. Servicing of this equipment should be performed by qualified service personnel only.
9. Do not let power cords touch hot surfaces.
10. Before wiring power supply, turn off electricity at fuseof circuit breaker.
Choose your mounting configuration (Side, Top, or Back Mount). Then plug the remaining holes with the
appropriate color plugs.
1. Secure the canopy bracket to the dependent object, such as the wall, ceiling, and so on.
2. Open the ALUMINUM cover.
3. Lock the ALUMINUM box and canopy with the screws.
4. Outlet the AC input leads (RED, BLACK, WHITE) from the ALUMINUM box and canopy's center hole, connect
the AC input leads to AC power supply leads, connect the RED lead to a 277VAC power supply and the
BLACK lead to a 120VAC power supply, WHITE lead to ground.
5. Lock the canopy into the canopy bracket with screws, then insert the battery wire terminal into the two pin male.
6. Snap the ALUMINUM cover.
Fulham Co. Inc.: 12705 South Van Ness Ave., Hawthorne, CA 90250 Tel.: 1-323-779-2980 Fax.: 1-323-754-9060.
Specifications subject to change without notice.
GENERAL INSTALLATION
GUIDELINES FOR
EMERGENCY EXIT SIGN
(FHEX24)
SAVE THESE INSTRUCTIONS
order@fulham.com www.fulham.com
20
Page 1 of 2
18 783
-
Rev A
Advertisement
Table of Contents
Related Manuals for Fulham FireHorse FHEX24
Summary of Contents for Fulham FireHorse FHEX24
- Page 1 5. Lock the canopy into the canopy bracket with screws, then insert the battery wire terminal into the two pin male. 6. Snap the ALUMINUM cover. Fulham Co. Inc.: 12705 South Van Ness Ave., Hawthorne, CA 90250 Tel.: 1-323-779-2980 Fax.: 1-323-754-9060. order@fulham.com www.fulham.com Specifications subject to change without notice.
- Page 2 GENERAL INSTALLATION GUIDELINES FOR EMERGENCY EXIT SIGN (FHEX24) Fulham Co. Inc.: 12705 South Van Ness Ave., Hawthorne, CA 90250 Tel.: 1-323-779-2980 Fax.: 1-323-754-9060. order@fulham.com www.fulham.com Specifications subject to change without notice. Page 2 of 2 18 783 Rev A...
Need help?
Do you have a question about the FireHorse FHEX24 and is the answer not in the manual?
Questions and answers