Declaration Of Conformity For Rf Exposure - Cisco BWX 8415 Installation And Commissioning Manual

Declarations of Conformity
instructions, may cause harmful interference. However, there is no guarantee that interference will not
occur. If this equipment does cause interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to correct the interference by one of the
following measures:
•
•
•
•
The Part 15 radio device operates on a non-interference basis with other devices operating at this
Warning
frequency when using Cisco-supplied antennas. Any changes or modification to the product not
expressly approved by Cisco could void the user's authority to operate this device.
To meet regulatory restrictions, the BS must be professionally installed.
Warning

Declaration of Conformity for RF Exposure

This Cisco product is designed to comply with the following national and international standards on
Human Exposure to Radio Frequencies:
•
•
•
•
•
•
For systems defined as Fixed Systems or systems that require professional installation for the antennas
or the antennas are roof mounted.
Note
For systems requiring On-Site evaluation See – statements for On-site evaluation
•
BWX 8415 Basestation Installation and Commissioning Guide
2-4
P R E L I M I N A R Y
Reorient or relocate the receiving antenna.
Increase separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from which the receiver is connected.
Consult the dealer or an experienced radio/TV technician.
US 47 Code of Federal Regulations Part 2 Subpart J
American National Standards Institute (ANSI) / Institute of Electrical and Electronic Engineers /
IEEE C 95.1 (99)
International Commission on Non Ionizing Radiation Protection (ICNIRP) 98
Ministry of Health (Canada) Safety Code 6. Limits on Human Exposure to Radio Frequency Fields
in the range from 3kHz to 300 GHz
Australia Radiation Protection Standard
To ensure compliance with various national and international Electromagnetic Field (EM F)
standards, the system should only be operated with Cisco approved antennas and accessories.
The minimum separation distance allowed is 2 meters. In these cases the distance is generally
greater than 1 meter, please verify actual MPE distance with project compliance engineer
US
This system has been evaluated for RF exposure for humans in reference to ANSI C 95.1 (American
National Standards Institute) limits. The evaluation was based on evaluation per ANI C 95.1 and
FCC OET Bulletin 65C rev 01.01.
Chapter 2 Regulatory Information and Declarations of Conformity
OL-19519-01