Jiffy Steamer ESTEAM Owner's Manual page 23

1. Attach hose firmly with included assembly wrench,
which is magnetized and located on the bottom of the
unit (figure #1). Assemble and attach hose hanger rod
set (figure #2). For "H" series models, there will be no
hose attachment or rod set to attach.
2. Using supplied funnel, add a maximum of four quarts
of warm (fresh tap or distilled) water (cold water takes
longer to heat). Do not overfill. The black water fill cap
has a pressure release feature that is designed to
activate should there be an increase of pressure in the
boiler tank (depends on model ordered). If you start to
see or hear steam escaping from the cap, check to see if
the hose has a kink or loop in it. If so, straighten out the
hose. If the escaping steam does not cease, please
contact Jiffy Steamer at 731-885-6690. Plug into
proper voltage outlet, turn switch to "STEAM". It will
take approximately 16 minutes for the unit to reach full
steam. The model J-4000 steamer contains a large
water reservoir and will provide 2 hours of continuous
steaming power. You may turn the rotary power switch to the "STANDBY"
position (figure #3) if you will be using your steamer intermittently throughout
the day. This will maintain the water temperature of the steamer and allow you
to turn the switch to the "STEAM" setting and quickly have full steam power.
3. The combined touch of the steaming head and the direct steam is very
important. Some articles can be steamed better from the underneath side.
Figure 3
water on a hot element. Resume steaming by resetting the
switch to the "STEAM" position.
4. Hang steam head and hose in upright position in the hose
hanger section (figure #4), turn switch to the "OFF" position
(figure #3) and unplug the cord set when not in use.
5. Periodically, pour old water out of steamer to avoid
sediment build up and maintain proper water level. Never
have more than 4 quarts of water in steamer. If overfilled,
water will boil up into hose. The Jiffy
every 6 months to flush mineral deposits. See page 29 for complete cleaning
instructions.
Every Jiffy Steamer has been factory tested and it is not uncommon for small amounts
®
of water to be in the unit.
WARNING: Never operate without water. Unplug after each use.
Jiffy
®
Always steam with hose in upright position so any
condensation is free to flow back into steamer. If steaming
in a low position near floor, straighten hose up and out
frequently to keep it clear of condensation. If steamer runs
dry it will temporarily shut off. Once finished using the
unit, turn the switch to the "OFF" position. If more water
needs to be added to the steamer, allow
steamer to cool before removing fill cap
and adding more water. Never pour cold
J-4000 Directions
Liquid Cleaner is recommended
®
Figure 1
Figure 2
Figure 4
23