® ® ® ® ®
SITRANS F M MAGFLO
2.3.1 Remote installation -
At the sensor
2.3.2 Remote installation -
Transmitter in 19"
insert
6
2. Installation
1. Fit the SENSORPROM
®
The SENSORPROM
®
unit is supplied with the sensor in the terminal box.
2. Mount the guide rails into the rack system as shown. Distance between guide rails is 20 TE.
Guide rails are supplied with the rack system and not with the transmitter.
3. Mount the connection board as shown.
4. Connect the cables as shown under "Electrical connection", chapter 7 in the handbook.
5. Insert the transmitter into the rack system.
SFIDK.PS.026.C2.02
Remove the SENSORPROM
sensor and mount it on the connection plate in
the transmitter.
Fit and connect the electrode and coil cables
as shown in chapter 7 "Electrical connections"
in the handbook.
The unscreened cable ends must be kept as
short as possible.
The electrode cable and the coil cable must be
kept separate to prevent interference.
Tighten the cable glands well to obtain opti-
mum sealing.
memory unit on the connection board supplied with the transmitter.
®
unit from the