Download  Print this page

Troubleshooting For Anynet - Samsung UA46B8000 User Manual

8 series.
Hide thumbs

Advertisement

Troubleshooting for Anynet +

¦
Problem
Anynet + does not work.
I want to start Anynet + .
I want to exit Anynet + .
The message
'Connecting to Anynet +
device...' appears on the
screen.
The Anynet + device does
not play.
The connected device is
not displayed.
The TV programme
cannot be recorded.
Possible Solution
Check if the device is an Anynet + device. The Anynet + system supports Anynet + devices
only.
Connect only one receiver (home theatre).
Check if the Anynet + device power cord is properly connected.
Check the Anynet + device's Video/Audio/HDMI 1.3 cable connections.
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
Check whether the TV remote control is in TV mode.
Check whether it is Anynet + exclusive remote control.
Anynet + doesn't work in certain situations. (Searching channels, Operating Media Play,
Plug & Play, etc.)
When connecting or removing the HDMI 1.3 cable, please make sure to search devices
again or turn your TV off and on again.
Check if the Anynet + Function of Anynet + device is set on.
Check if the Anynet+ device is properly connected to the TV and check if the Anynet +
(HDMI-CEC) is set to On in the Anynet + Setup menu.
Press the TV button on the TV remote control to switch to TV. Then press the TOOLS button
to show the Anynet + menu and select a menu you want.
Select View TV in the Anynet + menu.
Press the SOURCE button on the TV remote control and select a device other than Anynet +
devices.
Press P >/<, PRE-CH, and FAV.CH to change the TV mode. (Note that the channel
button operates only when a tuner-embedded Anynet + device is not connected.)
You cannot use the remote control when you are configuring Anynet + or switching to a view
mode.
Use the remote control when the Anynet + setting or switching to view mode is complete.
You cannot use the play function when Plug & Play is in progress.
Check whether or not the device supports Anynet + functions.
Check whether or not the HDMI 1.3 cable is properly connected.
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
Search Anynet + devices again.
You can connect an Anynet + device using the HDMI 1.3 cable only. Some HDMI cables may
not support Anynet + functions.
If it is terminated by an abnormal situation such as disconnecting the HDMI cable or power
cord or a power failure, please repeat the device scan.
Check whether the antenna jack on the recording device is properly connected.
English - 

Advertisement

Table of Contents

   Also See for Samsung UA46B8000

   Related Manuals for Samsung UA46B8000

This manual is also suitable for:

Ua55b8000

Comments to this Manuals

Symbols: 0
Latest comments: