Installation To A Flat Surface; Optional Pipe And Ceiling Mount Installation - Honeywell OELD Operating Instructions Manual

3.2.1 Installation to a Flat Surface

The OELD may be fixed directly to a suitable flat surface, using the integral mounting points (dimensions shown below).
Note
When installing OELD ensure that the correct sensor orientation is considered. Refer to the sensor manufacturer's instructions.
Ensure that mounting bolts are fully tightened and suitable locking washers are used.

3.2.2 Optional Pipe and Ceiling Mount Installation

The OELD may be fixed to a vertical pipe of 2" to 6" (50 to 150 mm) in diameter using the Pipe Mounting kit. This kit (1226A0358)
consists of one bracket, two sets of carriage bolts, nuts and lock washers.
The Ceiling Mount Bracket Kit (1226A0355) allows the OELD to be mounted to the ceiling. This kit includes two stainless steel
ceiling mount brackets, bolts and nuts.
7.8"
196.9 mm
6.0"
152.4 mm
5.6"
124.2 mm
42.4 mm
<Figure 5. OELD Dimensions>
<Figure 6. Pipe and Ceiling Mount Installation Examples>
4.5"
133.8 mm
0.6"
14.4 mm
1.7"
1.2"
31.8mm
3 Installation
2.1"
52.2 mm
0.6"
15.9 mm
1.8"
44.9 mm
1.8"
44.9 mm
3.2"
80.7 mm
0.9"
24.0mm
OELD Operating Instructions
9
6.1"
158.78mm