•
Do not use the product if you cannot receive aid if an
accident occurs. Always make sure others know you
will operate the product before you start to operate
the product.
•
Do not turn with the product before you make sure
that no persons or animals are in the safety area.
•
Remove all unwanted materials from the work area
before you start. If the cutting attachment hits an
object, the object can eject and cause injury or
damage. Unwanted material can wind around the
cutting attachment and cause damage.
•
Do not use the product in bad weather (fog, rain,
strong winds, risk of lightning or other weather
conditions.). Dangerous conditions (such as slippery
surfaces) can occur because of bad weather.
•
Make sure that you can move freely and work in a
stable position.
•
Make sure that you cannot fall when you use the
product. Do not tilt when you operate the product.
•
Always hold the product with your two hands. Hold
the product on the right side of your body.
•
Operate the product with the cutting attachment
below your waist.
•
If the choke control is in the choke position when the
engine starts, the cutting attachment starts to turn.
•
Do not touch the bevel gear after the engine stops.
The bevel gear is hot after the engine stops. Hot
areas can cause injury.
•
Stop the engine before you move the product.
•
Do not put down the product with the engine on.
•
Before you remove the unwanted materials from the
product, stop the engine and wait until the cutting
attachment stops. Let the cutting attachment stop
before you or an aid remove the cut material.
Personal protective equipment
•
Always use correct personal protective equipment
when you operate the product. The personal