Register A Tag - Honeywell Domonial CMI Series Installer Manual

E

Register a TAG

N
To meet the requirements of EN50131-1 a TAG must be used to arm and disarm the system.
G
Therefore, it may be necessary to register a TAG during the installation process.
L
Note: We recommend you register a TAG and always use it to arm and disarm the system, even if
it is not a mandatory requirement.
I
1. On the TCU, press
S
highlight USERS.
2. Press
H
3. Press
USER ACCESS screen is displayed.
4. Enter the 6-digit Master User Code. The TAGS screen is
displayed, with M (the master user) highlighted.
5. Press
6. Press
7. Place your master TAG close to the TCU keypad TAG reader
(between, and below the
The ACCEPT NEW TAG message is displayed?
8. Press
9. The TAG is now registered and can be used to arm and disarm the system.
Page 17 of 52
to wake up the keypad, and then press
, to access the USERS screen.
to highlight TAGS, and then press
to display the TAGS ALLOWED ? message.
to display the PRESENT TAG message.
and
to accept the new TAG.
. The
buttons).
again to
02/2011