Husqvarna Soff-Cut 150 D Operator's Manual page 18

Problem
Bevel or radius cut incon-
sistent (Soff-Cut 150 D)
The product pulls to one
side while sawing, Soff-
Cut 150
The product pulls to one
side while sawing, Soff-
Cut 150 D
18
Solution
Check to see if the diamond blade is worn out, glazed, warped or damaged.
Ensure front and rear guide wheels can move freely up and down without binding.
Ensure front and rear guide wheels can spin freely.
Do not push the product too fast. Sawing too fast will cause the blade to ride up out of
the concrete.
Make sure the guide wheels are aligned in the pre-existing saw cut before starting.
Make sure the existing saw cuts are clean and free of debris.
Check lexan covers for free movement up and down.
Ensure there is spring down pressure at each end of the skid plate.
Do not twist or move the product sideways while cutting. Make gradual changes in
pressure on the handlebar to control the saw in the cut.
Check that the engine is running properly and at full throttle.
Check belt and belt idler for proper tension.
Ensure the diamond blade is properly mounted and secured with clean flanges.
Ensure the slab is in clean with no debris that could raise the saw while cutting.
Clean excess concrete debris from the blade block assembly.
Check that the scrapers in the blade block are not bent or binding.
Ensure that the blade block shafts are not bent or damaged.
Re-cut the joint in the opposite direction.
Check that the front guide is properly aligned with the center of the diamond blade
Check the skid plate for damage or burrs.
Check front and rear guide is properly aligned with the center of the diamond blade.
Check to see if the diamond blade is worn out, glazed, warped or damaged.
Do not twist or move the saw sideways while cutting. Make gradual changes in pres-
sure on the handlebar to control the saw in the cut.
Ensure that all wheels rolls freely and smoothly.
Do not force the saw. Allow the diamond blade to cut at its own rate of speed.
714 - 002 - 09.04.2018