Connecting Cable Tv - Samsung HP-S6373 Owner's Instructions Manual

Connecting Cable TV

To connect to a cable TV system, follow the instructions below.
Cable without a Cable Box
ANT 1 IN (CABLE)
Connecting to a Cable Box that Descrambles All Channels
ANT IN
ANT OUT
ANT 1 IN (CABLE)
Connecting to a Cable Box that Descrambles Some Channels
If your cable box descrambles only some channels (such as premium channels), follow the instructions below. You will need a two-way
splitter, an RF (A/B) switch, and four lengths of Antenna cable. (These items are available at most electronics stores.)
Incoming
cable
Incoming
cable
Splitter
Incoming
cable
Splitter
Incoming
cable
Splitter
After you have made this connection, set the A/B switch to the "A" position for normal viewing. Set the A/B switch to the "B" position to view scrambled
channels. (When you set the A/B switch to "B", you will need to tune your TV to the cable box's output channel, which is usually channel 3 or 4.)
1. Plug the incoming cable into the ANT 1 IN (CABLE) terminal on the back of the TV.
➢
Because this TV is cable-ready, you do not need a cable box to view unscrambled cable channels.
1. Find the cable that is connected to the ANT OUT terminal on your cable box.
➢
This terminal might be labeled "ANT OUT", "VHF OUT" or simply, "OUT".
2. Connect the other end of this cable to the ANT 1 IN (CABLE) terminal on the back of the TV.
ANT IN
Incoming
cable
Splitter
Splitter
Cable Box
Cable Box
RF (A/B)
Switch
Cable Box
1. Find and disconnect the cable that is
2. Connect this cable to a two-way splitter.
3. Connect an Antenna cable between an
Cable Box
4. Connect an Antenna cable between the
RF (A/B)
Switch
5. Connect another cable between the other
RF (A/B)
Switch
6. Connect the last Antenna cable between the
TV Rear
ANT 1 IN (CABLE)
English-10
connected to the ANT IN terminal on your
cable box.
➢
This terminal might be labeled "ANT IN",
"VHF IN" or simply, "IN".
OUTPUT terminal on the splitter and the
IN terminal on the cable box.
ANT OUT terminal on the cable box and
the B–IN terminal on the RF(A/B) switch.
OUT terminal on the splitter and the A–IN
terminal on the RF (A/B) switch.
OUT terminal on the RF (A/B) switch and
the ANT 1 IN (CABLE) terminal on the rear
of the TV.