BN68-00678A-01_024~65
2004.4.28
Storing Channels in Memory (Automatic Method)
First, select the correct signal source (Air, STD, HRC
1
and IRC). See steps on previous page.
Press the MENU button. Press the ▲ or ▼ button to
select "Channel", then press the ENTER button.
Press the ▲ or ▼ button to select "Auto Program",
2
then press the ENTER button.
➤
➤
Quick way to access the Automatic Channel Setting: Just press the
"AUTO PROG." button on the remote control.
Press the ENTER button.
3
The PDP will begin memorizing all of the available
channels.
After all the available channels are stored, the Auto
pro gram menu reappears.
Press the ENTER button to stop.
Press the MENU button to exit.
4
Note
• The PDP automatically cycles through all of the available channels and stores them in memory.
This takes about one to two minutes.
30
6:14 PM
Page 30
Channel
TV
Air/CATV
: Air
Auto Program
Add/Delete
Fine Tune
LNA
: On
Scan
Move
Enter
TV
Channel
Air/CATV
: Air
Auto Program
Add/Delete
Fine Tune
LNA
: On
Scan
Move
Enter
Auto Program
Start
Enter
√
√
√
√
√
√
Return
√
√
√
√
√
√
Return
Return