Memorizing The Channels - Samsung HP-P4261 Owner's Instructions Manual

BN68-00678A-01_024~65 2004.4.28
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of signal
source that is connected to the PDP (i.e., an antenna or a cable system).
Press the MENU button. Press the ▲ or ▼ button to
1
select "Channel", then press the ENTER button.
2
Press the ▲ or ▼ button to select "Air", "STD",
3
"HRC" or "IRC", then press the ENTER button.
• If you are connected to an antenna, leave "Air"
Press the MENU button to exit.
4
Note
• STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company to
identify the type of cable system that exists in your particular area. At this point the signal source
has been selected. Proceed to "Storing Channels in Memory" (Next page).
6:14 PM Page 29

Memorizing the Channels

Your PDP can memorize and store all of the available channels for both "off-air"
(antenna) and cable channels. After the available channels are memorized, use the
CH and CH
change channels by entering the channel digits. There are three steps for memorizing
channels: selecting a broadcast source, memorizing the channels (automatic) and
adding and deleting channels (manual).
Press the ENTER button to select "Air/CATV".
displayed. If you connected cable, press the
▲ or ▼ button to the display the type of cable
system: "STD", "HRC" or "IRC".
(If you are not sure which type of cable system you
have, contact your cable company).
buttons to scan through the channels. This eliminates the need to
TV
TV
TV
Channel
Air/CATV : Air √
Auto Program √
Add/Delete √
Fine Tune √
LNA : On √
Scan √
Move Enter Return
Channel
Air/CATV : Air
Air
Auto Program
STD
Add/Delete
HRC
Fine Tune
IRC
LNA : On
Scan
Move Enter Return
Channel
Air/CATV : Air
Air
Auto Program
STD
Add/Delete
HRC
Fine Tune
IRC
LNA : On
Scan
Move Enter Return
29