After Removing The Watercraft From The Water - Yamaha 2017 WaveRunner EX Owner's/Operator's Manual

Operation
area, clean the jet intake. (See page 92 for in-
formation on the jet intake.)
EJU40242
After removing the watercraft from
the water
ECJ01311
NOTICE
Do not run the engine over 4000 r/min on
land. Also, do not run the engine for more
than 15 seconds without supplying water,
otherwise the engine could overheat.
After operating and removing the watercraft
from the water, promptly discharge the re-
maining water from the cooling water pas-
sages.
To discharge water from the cooling water
passages:
(1) Make sure that the area around the wa-
tercraft is clear, and then start the en-
gine.
(2) Discharge the remaining water out of the
cooling water passages by alternately
squeezing and releasing the throttle lever
quickly for 10 to 15 seconds.
(3) Stop the engine.
76