Inlet Connection
The appliance is sup-
plied with a fl ared elbow
connector fi tted onto the
valve and a fl ex connec-
tor supplied loose to be
attached to the elbow
connector. To facilitate
the installation of the fl ex
connector, remove the
valve access panel on
the left side of the appli-
ance case.
NOTE: the fl ex
connector minimum
bend radius must be no
smaller than the size of a
golf ball (approx. 1-3/4" or 44 mm) as indicated.
Alternate Inlet Connection
When the fi replace opening width is too narrow, you
may use common elbows and fi ttings (not supplied) to
redirect the position of the fl ex connector closer to the
side of the appliance.
1. Remove elbow connector.
Installation
6-3/8"
(162 mm)
Gas
line exit
13-1/4"
(337 mm)
2. Install alternate elbow (not supplied).
3. Re-install original supplied connector elbow.
4. Install the fl ex connector to the alternate elbow.
QUALIFIED
INSTALLER
3/8" street elbow(s)
(where allowed)
OR
3/8" elbow
+ short
3/8" nipple
31