Use
6.15
Dismantling the hopper
For accurate cleaning of the hopper (1), dismantle all its components.
To do so, follow the instructions given below in order to avoid possible damage to the
equipment.
Fig. 6.6
Hopper
1.
Make sure that the driving shafts -which transmit the motion to the rollers (2)- are
correctly positioned. Their bearing section must be positioned as shown in the figure
below. Should the shafts not be correctly fitted, move the rollers by hand until the
shafts reach their correct position.
Bisky
06_Uso_en.fm
1
2
page 77