Data Record 93 - Write Commands - Siemens SIRIUS PROFINET Manual

A.1.11

Data record 93 - Write commands

Structure of the command data record
Byte
Header
0
1 ... 3
Command
4
5
6
7
8
9
Code Command
1-byte
commands
0 Reserved = 0
1 Trip Reset
2 Emergency start ON
3 Emergency start OFF
4 Automatic mode
5 Manual mode
6 Basic factory settings
7 Reset maximum pointer
9 Restart
10 Parameters disabled
CPU/master ON
11 Parameters disabled
CPU/master OFF
13 Log list - Delete trips
14 Log list - Delete events
PROFINET Communication Module for SIRIUS Soft Starter 3RW44
Manual, 12/2013, A5E31996495002A/RS-AA/001
Meaning
Coordination
Reserved = 0
Number of commands
Command 1
Command 2
Command 3
Command 4
Command 5
Meaning
No function
Resetting and acknowledging of error messages
Switch on emergency start
Switch off emergency start
Transition to automatic mode (control by CPU/master)
Transition to manual mode. The soft starter switches to manual bus mode
or manual operation local mode depending on the interface via which the
command is received. This command can be used to obtain control
priority but not to give it up.
Restore the basic factory settings of the parameters.
The measured values for preventive diagnostics are deleted (= 0).
Initiate a restart (same as after power ON), e.g., after reassignment of the
station address.
Parameter assignment by the parameter-assigning CPU or master is not
possible, or its parameters are ignored.
Parameter assignment by the parameter-assigning CPU or master is
possible.
Delete log list of recorded error causes.
Delete log list of recorded alarms and specific actions.
A.1 Data formats and data records
Comment
0x20 Write via C1 channel (PLC)
Value range 1 ... 5
Number of subsequent valid commands
Sequential no., see table below
Optional (coding, see table below)
Optional (coding, see table below)
Optional (coding, see table below)
Optional (coding, see table below)
Appendix
93