Download  Print this page

Solving Printer Problems - HP 280 G3 Maintenance And Service Manual

Small form factor business pc.
Hide thumbs


There is no sound or sound volume is too low.
The application is set to use a different audio device than
Some applications can select which audio output device is used.
The operating system controls may be set to use a different audio
device as the default output device than what is expected.

Solving printer problems

If you encounter printer problems, see the documentation that came with the printer and to the common
causes and solutions listed in the following table.
Printer will not print.
Printer is not turned on and online.
The correct printer drivers for the application are not installed.
If you are on a network, you may not have made the connection
to the printer.
Printer may have failed.
Printer will not turn on.
The cables may not be connected properly.
Chapter 6 Troubleshooting without diagnostics
Some graphics cards support audio over the DisplayPort
connection (if applicable), so multiple audio devices may be listed
in Device Manager. Make sure the correct device is being used.
To access Device Manager in Windows 7, click Start, select Control
Panel, and then select Device Manager.
To access Device Manager in Windows 10, type device
manager in the taskbar search box, and then select Device
Manager from the list of applications.
Make sure the application has selected the correct audio device.
Set the operating system to use the correct audio device.
Turn the printer on and make sure it is online.
Install the correct printer driver for the application.
Try printing using the MS-DOS command:
DIR C:\ > [printer port]
where [printer port] is the address of the printer being
used. If the printer works, reload the printer driver.
To run MS-DOS commands, press the Windows key + r, type cmd
in the Open box, and then click OK.
Make the proper network connections to the printer.
Run printer self-test.
Reconnect all cables and check the power cord and electrical


Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: