Solving Hard Drive Problems - HP 280 G3 Maintenance And Service Manual

Solving hard drive problems

Hard drive error occurs.
Cause
Hard disk has bad sectors or has failed.
Disk transaction problem.
Cause
Either the directory structure is bad or there is a problem with a
file.
Drive not found (identified).
Cause
Cable could be loose.
The system may not have automatically recognized a newly
installed device.
The device is attached to a SATA port that has been hidden in
Computer Setup.
Drive responds slowly immediately after power-up.
Solution
1. In Windows 7, click Start, click Computer, and right-click on
a drive. Select Properties, and then select the Tools tab.
Under Error-checking click Check Now.
In Windows 10, type file in the taskbar search box, and
then select File Explorer from the list of applications. In the
left column, expand This PC, right-click on a drive, select
Properties, and then select the Tools tab. Under Error
checking click Check.
2. Use a utility to locate and block usage of bad sectors. If
necessary, reformat the hard disk.
Solution
In Windows 7, click Start, expand Computer, and right-click on a
drive. Select Properties, and then select the Tools tab. Under
Error-checking click Check Now.
In Windows 10, type file in the taskbar search box, and then
select File Explorer from the list of applications. In the left
column, expand This PC, right-click on a drive, select Properties,
and then select the Tools tab. Under Error checking click Check.
Solution
Check cable connections.
See reconfiguration directions in the
Installation Problems on page 66
does not recognize the new device, check to see if the device is
listed within Computer Setup. If it is listed, the probable cause is a
driver problem. If it is not listed, the probable cause is a hardware
problem.
If this is a newly installed drive, run the Computer Setup utility
and try adding a POST delay under Advanced > Boot Options.
Run the Computer Setup utility and ensure Device Available is
selected for the device's SATA port in Advanced > Port Options.
Run Computer Setup and increase the POST Delay in Advanced >
Boot Options.
Solving hard drive problems
Solving Hardware
section. If the system still
55