Computer Setup-Power; Computer Setup-Advanced - HP 280 G3 Maintenance And Service Manual

Computer Setup—Power
NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration.
Option
OS Power Management
Hardware Power
Management
Thermal
Computer Setup—Advanced
NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration.
Option
Power-On Options
BIOS Power-On
Bus Options
Device Options
46 Chapter 5 Computer Setup (F10) Utility
Description
● Runtime Power Management— Enable/Disable. Allows certain operating systems to reduce
processor voltage and frequency when the current software load does not require the full
capabilities of the processor. Default is enabled.
● Idle Power Savings—Extended/Normal. Allows certain operating systems to decrease the
processors power consumption when the processor is idle. Default is extended.
SATA Power Management – Enables or disables SATA bus and/or device power management. Default is
enabled.
CPU Fan Speed—Display current fan speed.
Heading
Allows you to set:
● POST messages (enable/disable). Enabling this feature will cause the system to display POST error
messages, which are error messages displayed on the monitor during the Power On Self Test if the
BIOS encounters some kind of problem while starting the PC. A POST error message will only display
on screen if the computer is capable of booting this far. If the POST detects an error before this
point, a beep code is generated instead. Default is disabled.
● After Power Loss (off/on/previous state). Default is Power off. Setting this option to:
– Power off—causes the computer to remain powered off when power is restored.
– Power on—causes the computer to power on automatically as soon as power is restored.
– Previous state—causes the computer to power on automatically as soon as power is restored,
if it was on when power was lost.
NOTE: If you turn off power to the computer using the switch on a power strip, you will not be able to
use the suspend/sleep feature or the Remote Management features.
POST Delay (in seconds). Enabling this feature will add a user-specified delay to the POST process.
●
This delay is sometimes needed for hard disks on some PCI cards that spin up very slowly, so slowly
that they are not ready to boot by the time POST is finished. The POST delay also gives you more
time to select F10 to enter Computer (F10) Setup. Default is None.
● Remote Wakeup Boot Source (remote server/local hard drive). Default is Local hard drive.
Allows you to set the computer to turn on automatically at a time you specify.
Allows you to enable or disable:
● PCI SERR# Generation. Default is enabled.
● PCI VGA Palette Snooping, which sets the VGA palette snooping bit in PCI configuration space; only
needed when more than one graphics controller is installed. Default is disabled.
Allows you to set:
● Num Lock State at Power-On (off/on). Default is off.
● Multi-Processor (enable/disable). Default is enabled.