Removing And Installing Dimms - HP 280 G3 Maintenance And Service Manual

Small form factor business pc
Table of Contents

Advertisement

The system will operate in single channel mode if the DIMM sockets are populated in one channel only.
The system will operate in a higher-performing dual channel mode if the memory capacity of the DIMM
in Channel A is equal to the memory capacity of the DIMM in Channel B.
The system will operate in flex mode if the memory capacity of the DIMM in Channel A is not equal to the
memory capacity of the DIMM in Channel B. In flex mode, the channel populated with the least amount
of memory describes the total amount of memory assigned to dual channel and the remainder is
assigned to single channel. If one channel will have more memory than the other, the larger amount
should be assigned to Channel A.
In any mode, the maximum operational speed is determined by the slowest DIMM in the system.

Removing and installing DIMMs

CAUTION:
You must disconnect the power cord and wait approximately 30 seconds for the power to drain
before adding or removing memory modules. Regardless of the power-on state, voltage is always supplied to
the memory modules as long as the computer is plugged into an active AC outlet. Adding or removing
memory modules while voltage is present may cause irreparable damage to the memory modules or system
board.
The memory module sockets have gold-plated metal contacts. When upgrading the memory, it is important
to use memory modules with gold-plated metal contacts to prevent corrosion and/or oxidation resulting from
having incompatible metals in contact with each other.
Static electricity can damage the electronic components of the computer or optional cards. Before beginning
these procedures, ensure that you are discharged of static electricity by briefly touching a grounded metal
object.
When handling a memory module, be careful not to touch any of the contacts. Doing so may damage the
module.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Remove the optical drive
5.
Remove the drive cage
6.
To remove a memory module, open both latches of the memory module socket (1), and then remove the
memory module from the socket (2).
7.
To install a memory module, open both latches of the memory module socket (1), and insert the
memory module into the socket (2).
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page
21).
(Optical drive on page
(Hard drive on page
25).
16).
23).
15).
Memory
29

Advertisement

Table of Contents
loading

Table of Contents