Pci 155 Mbps Unshielded Twisted Pair Atm Ioa - IBM AS/400e User Handbook Manual

I/O Adapter
On new systems from the plant, the #4801 is shipped with the system, but not installed.

#4815 PCI 155 Mbps Unshielded Twisted Pair ATM IOA

This feature allows the AS/400 system to be attached to an Asynchronous Transfer Mode
(ATM) network using the Unshielded Twisted Pair (UTP-5) interface. This interface is intended
for connection to both local area switches and direct connection to service provider
equipment. The #4815 is typically used where 155 Mbps speeds are required over distances
of less than 100 meters.
#4816 PCI 155 Mbps Multi-Mode Fiber OC3 ATM IOA
This feature allows the AS/400 system to be attached to an Asynchronous Transfer Mode
(ATM) network using the Multi-Mode Fiber (MMF) 62.5 micron interface. This interface is
intended for connection to both local area switches and direct connection to service provider
equipment. The #4816 is typically used where 155 Mbps speeds are required over distances
of less than 2 km.
#4818 PCI 155 Mbps Single-Mode Fiber OC3 ATM IOA
This feature allows the AS/400 system to be attached to an Asynchronous Transfer Mode
(ATM) network using the Single-Mode Fiber (SMF) 9 micron interface. This interface is
intended primarily for direct connection to service provider equipment but can be used for
local area switches. The #4818 is typically used where 155 Mbps speeds are required over
distances from 16 to 40 km.
#4838 PCI 100/10 Mbps Ethernet IOA
This feature allows the AS/400 system to attach to a standardized 100 Mbps high-speed
Ethernet LAN. It also allows attachment to existing 10 Mbps Ethernet LANs. The adapter
comes with an RJ45 connector for attachment to UTP-5 media. Cabling for 10 Mbps must be
CAT-3 or CAT-5, cabling for 100 Mbps must be CAT 5 that meets or exceeds Industry
Standard EIA/TIA T568A or T568B. The maximum cable length is 100 meters. The
Ethernet/IEEE 802.3 IOA is capable of operating in half or full duplex mode.
If the #4838 is selected to run on a #2790 or #2890 Integrated Netfinity Server, one #0224
(100/10Mbps Ethernet on Integrated Netfinity Server) is required for each #4838 ordered.
#9771 Base PCI 2-Line WAN with Modem
#9771 is a 2-line WAN adapter, with one port supporting multiple protocol communications and
the other port supporting V.90 56K Async Data on PPP via an internal modem. Connection to the
V.90 port is via telephone cable.
256
AS/400e System Handbook