Siemens SIMATIC PCS 7 Manual page 38

Process control system. connecting tm i/o to pcs 7

Hide thumbs Also See for SIMATIC PCS 7:

Table of Contents

Configuration

4-14

.S5_Typ=DA1; Only enter if operating EG driver type 0, 1 or 2 with

CNO=4.

.Kanal=5;

Only enter if operating EG driver type 0, 1/KNR=5 or

type 2/KNR=4.

.S5_Typ=DA1; Only enter if operating EG driver type 0, 1/CNO=5 or

type 2/CNO=4.

Kanal=6;

Only enter if operating EG driver type 0, 1 or 2 with

CNO=6.

.S5_Typ=DA1; Only enter if operating EG driver type 0, 1 or 2 with

CNO=6.

.Kanal=7;

Only enter if operating EG driver type 0, 1/KNR=7 or

type 2/CNO=6.

.S5_Typ=DA1; Only enter if operating EG driver type 0, 1/KNR=7 or

type 2/CNO=6.

The configuration must be adapted every time a driver is installed or unin-

stalled. However, alternatively it is possible to initially configure all channels

and drivers and next link the unused drivers to a source in order to switch

over their manual/auto mode in synchronism to the other drivers.

Also, all TM_EG blocks assigned to one module must follow each other im-

mediately in the same block. They must be switch on or off all at once.

Connecting TM I/O to PCS 7

C79000-G8076-C710-04

Table of Contents