Connecting A Camcorder - Samsung DynaFlat TX R2765 Owner's Instructions Manual

I
N S TA L L AT I O N

Connecting a Camcorder

The side panel jacks on your TV make it easy to connect a camcorder to your TV. They allow
you to view the camcorder tapes without using a VCR. (Also see "Viewing an External Signal
Source" on page 39).
1
Locate the A/V output
jacks on the camcorder.
They are usually found
on the side or back of
the camcorder.
2
Connect an audio cable
between the AUDIO
OUTPUT jack on the
camcorder and the
AUDIO terminals on the
side of the TV.
3
Connect a video cable
between the VIDEO
OUTPUT jack on the
camcorder and the
VIDEO terminal on the
side of the TV.
The audio-video cables shown here are usually included with a Camcorder. (If not, check
your local electronics store.) If your camcorder is stereo, you need to connect a set of two
cables.
Note: This figure shows the Standard connector-jack panel. The actual configuration for
your TV may be different.
20
Camcorder
Output Jacks
Camcorder
Output Jacks
Audio Cable
Camcorder
Output Jacks
Video Cable
Y-Connector
TV Side Panel
TV Side Panel