Connecting An S-Vhs Vcr - Samsung DynaFlat TX R1635 Owner's Instructions Manual

I
N S TA L L AT I O N
Connecting an S-VHS VCR (Depends on the model)
Your Samsung TV can be connected to an S-Video signal from an S-VHS VCR.
(This connection delivers a better picture as compared to a standard VHS VCR.)
1
To begin, follow steps
1–3 in the previous
section to connect the
antenna or cable to your
VCR and your TV.
2
Connect a set of audio
cables between the
AUDIO OUT jacks on the
VCR and the AUDIO
INPUT2 jacks on the TV.
3
Connect an S-video cable
between the S-VIDEO OUT
jack on the VCR and the
S-VIDEO IN jack on the
TV.
An S-video cable is usually included with an S-VHS VCR. (If not, check your local
electronics store.)
Note: This figure shows the Standard connector-jack panel. The actual configuration for your TV
may be different.
14
VCR Rear Panel
Coaxial Cable
VCR Rear Panel
Audio Cable
VCR Rear Panel
S-Video Cable
TV Rear Panel
TV Rear Panel
TV Rear Panel