2. Installing the Product 2-1. Package Contents • Unpack the product and check if all of the following contents have been included. • Store the packaging box in case you need to move the Product at a later stage. Contents Installation Manual Power Cord Stand...
Page 3
Check if the Stand Connector is firmly connected. Turn the connecting screw at the bottom of the stand fully so that it is completely fixed. Place a soft cloth over the table to protect the product and place the product onto the cloth so that the front of the product is facing downwards.
2-3. Removing the Stand Before removing the stand, place the product down on a flat and stable surface so that the screen faces downwards. 2-4. Installing the Stand for the Wall Mount This product provides a stand mount of 75 mm x 75 mm that complies with the VESA specifications. Place a soft cloth over the table to protect the product and place the product onto the cloth so that the front of the product faces downwards.
A. Stand Mount B. Stand (Optional) Turn the product off and unplug the power cord from the wall outlet. Place a soft cloth or cushion on a flat surface to protect the panel and place the product down on the cloth so that the front of the product faces downwards.
• Connect the [DVI IN] port of the product to the DVI port of the PC with the DVI cable.. Connect one end of the power cord to the POWER port of the product and connect the other end of the power cord to the 220V or 110V wall outlet.
In this case, if a blank screen is displayed again, make sure that there is no problem with the PC and the connection. The product is working properly. 5-2. Before Requesting Service Please check the following before requesting After-Sales service. If the problem continues, please contact your nearest Samsung Electronics Service Center. Is the power cord connected properly? Is the "Check Signal Cable"...
Page 8
The color is displayed in 16 bit (16 colors). The color has been changed after changing the graphics card. Did you install the device driver for the product? Is the graphics card configured correctly? When I connect the monitor, the 'Unknown monitor, Plug&Play (VESA DDC) monitor found' message is displayed. Did you install the device driver for the product? Check if all the Plug&Play (VESA DDC) functions are supported refer- ring to the User Manual of the graphics card.